Sdg Router Showbox Command Output - IBM TotalStorage DS4000 Hardware Maintenance Manual

showBox
Figure 72. SDG Router showBox command output
sysConfigShow
sysVpdShow or sysVpdShowAll
130
IBM TotalStorage DS4000: Hardware Maintenance Manual
Width The negotiated transfer width in bits, either 8 or 16
The showBox command displays the components currently in the SDG
Router using characters to form a picture of the unit, as viewed from the
rear. Figure 72 demonstrates how the showBox command displays a SDG
Router that has a single-port fibre channel PMC installed.
Note: For SAN connection port-number assignments, see the Storage Area
Network Data Gateway Router Service Guide.
The sysConfigShow command displays the current system parameter
settings.
The display shows whether the SDG Router command and control
interface is enabled or disabled. It also shows the LUN that is assigned to
it, whether enhanced tape performance features are enabled, the MAC
address of the Ethernet port, and the SDG Router fibre channel node
address.
Router > sysConfigShow
Current System Parameter Settings:
Command and Control Device (CC) : 0 Enabled
LUN : 0
Allow Early Write Status for Tape : 1 Enabled
Allow R/W Acceleration for Tape : 1 Enabled
Enet MAC Address: 0.60.45.16.1.4
FC Node WWN: 10000060.45160104
value =0 =0x0 Router >
The sysVpdShow command displays vital product data (VPD)
information. The VPD for the SDG Router includes such items as serial
numbers and installed memory sizes.