Understanding The Printer Front Panel - Intermec EasyCoder 3400 Getting Started Manual

Understanding the Printer Front Panel

On the front panel of your printer, you will find one button and three light emitting diodes
(LEDs). Use the front panel LEDs to monitor the status of the printer:
Power
Green LED
Orange LED Alert
Yellow LED
Empty/Pause
Feed/Pause
Note: The green LED on the 3440 printer front panel reads Power/Data.
The Feed/Pause button performs the following functions depending on the status of the printer:
Printer Mode You Want To
Idle Feed out one label or a
minimum specified amount
of media.
Continuously feed media.
Take the printer offline.
Printing Pause the printer.
Cancel the current print job.
Powered on for Print the hardware
the first time configuration test label.
2
LED State Indication
Power Off Power off
Flashing Receiving data
On Power on
Off Printing or idle
Alert Flashing Over-temperature
On System fault
Off Printing or idle
Empty/Pause Flashing Paused
On Media fault
3440G.002
What To Do
Press and release the Feed/Pause button.
Press and hold the Feed/Pause button. When
you release the button, the media stops feeding.
Press the Feed/Pause button twice. Press the
button again to bring the printer online.
Press and release the Feed/Pause button. Press
and release the button again to resume printing.
Press and hold the Feed/Pause button until the
printer stops printing.
Press and hold the Feed/Pause button. See
"Testing Printer Operation" later in this
guide for more information.
5
In te
rm e
A
Lit ton c
Co
mp an
3 4 y
0 0
3440G.034
Use a lint-free cloth moistened with alcohol to remove
any dirt, adhesive, or debris from the print surface on
the bottom of the printhead.
Wait 5 to 10 seconds for the print surface to dry.
7
3440G.021
Engage the printhead by rotating the head lift lever
counterclockwise until it locks in place.
6
In te In te
rm e rm e
c c
3 4
4 0
3440G.046
Replace the media and ribbon.
8
3440G.022
Replace the media cover.
23