THOMSON TWG870 User Manual page 64

Chapter 2: WEB Configuration
Automatic Security Configuration
WiFi Protected Setup (WPS) is an easy and secure way of configuring and connecting your WiFi
access point. In your case, the TWG870 is the Access Point (AP), and Your PC (or Wifi Device) is
called the STA. When configuring your Wifi Network via WPS, Messages are exchanged between
the STA and AP in order to configure the Security Settings on both devices.
WPS Config: It will help you to Enable or Disable the WPS feature. To enable you need to
select WPS, to disable you need to select Disabled.
Note: After you Enabled the WPS you will get the options as show in Fig.35 and the WPS
Config State box will show its configuration status.
Device Name: By using this you can change the factory default to a name of your choice which
is up to 32 characters long as like SSID.
WPS Setup AP: Here you do not need to change anything, just skip this step.
WPS Add Client: There are two methods "Push-Button" and "PIN". Select the method you
want.
But, the default selection will be "PIN".
Illustrations contained in this document are for representation only.
Fig. 41 Automatic Security Configuration
61