Rip (Routing Information Protocol) Setup - THOMSON TWG870 User Manual

Chapter 2: WEB Configuration

8. RIP (Routing Information Protocol) Setup

This feature enables the gateway to be used in small business situations where more than one LAN
(local area network) is installed. The RIP protocol provides the gateway a means to "advertise"
available IP routes to these LANs to your cable operator, so packets can be routed properly in this
situation.
Your cable operator will advise you during installation if any setting changes are required here.
Fig. 29 Gateway\Advanced\RIP Setup
48
Illustrations contained in this document are for representation only.