Table of Contents
Advertisement
Aging Timeout: It allows you to enter the update period for the MAC table.
Have this number lower if you want a more frequent refresh rate.
Range: 0 - 32767
6.6 RIP Configuration
RIP (Routing Information Protocol) is a management protocol that ensures that all hosts in a particular
network share the same information about routing paths.
The RIP Configuration page allows you to set the configuration for the system wide configuration of RIP.
The actual RIP configuration is in the RIP Per Interface Configuration.
RIP: It allows you to Enable or Disable the RIP session. The resulting RIP session will monitor all network
interfaces that are currently available for messages from other RIP routers. RIP is disabled by default.
Border Gateway: RIP implements Border Gateway as specified in RFC 1058 and RFC 1723. This limits all
subnet routes and host routes to routers within that same network.
Updates sent outside that network will only include a single entry representing the entire network, including
all subnets and host-specific routes. The Border Gateway is enabled by default.
Default: 100
31
Advertisement
Table of Contents
