Video
Overscan
The edge of the image may or may not be displayed correctly, this function allows you to set
Overscan On to crop the the border area of the image.
The function is available for 480p, 576P, 720p, 1080i and 1080p from COMPUTER 1/2, COMPONENT or DVI-D input.
Video System
Set the Video System to Auto unless the projector cannot receive the signal or a clear image,
selectable Video signal are Auto, PAL, SECAM, NTSC4.43, NTSC3.58, PAL-M, PAL-N and PAL-60.
Video System can only be set in Video or S-Video mode.
Video Setup
Set the black level to 0 IRE or 7.5IRE.
This function is available for 480I from COMPUTER 1/2, COMPONENT, NTSC3.58 from Video or
S-Video input.
Closed Caption
Set to CC1 or Off as required.
This function is available in following case
•
The signal is NTSC 3.58
•
Not all programs and video will offer closed Caption, please make sure they offer Close
41