Start The Boiler - Weil-McLain Gold CGi 2 Series Manual

CGi
GOLD GAS-FIRED WATER BOILER — SERIES 2 —
7b

Start the boiler

• Follow the
to start the boiler.
Section 7c
• See
Check system and boiler
Check system piping for leaks.
1.
boiler and repair immediately.
Vent air from system
2.
the system will interfere with circulation and cause
heat distribution problems and noise.
Inspect vent system
3.
deterioration from corrosion, physical damage or
sagging. In addition — Check for gas-tight seal at
every connection and seam.
34
Start-up — operate boiler
DO NOT
proceed with boiler
operation unless boiler and
system have been filled with
water and all instructions and
procedures of previous manual
sections have been completed.
Failure to do so could result in
severe personal injury, death or
substantial property damage.
Before starting the boiler, do
the following:
Section 9
• Read manual
Operating instruction
the
procedure applicable for
the gas valve supplied on the
9c
boiler (Section ).
• Verify the boiler and system
full of water
are .
Start-up prepa-
• Verify the
ration
procedures of
tion 7
have been completed.
Operating instructions from Section
if boiler fails to start.
If found, shut down
using manual vents. Air in
thoroughly for signs of
Boiler Manual
and
Sec-
9c
Check around the boiler
4.
procedure of Section
Verify operation
5.
procedure in Section
and service certificate
If you discover evidence of any
gas leak, shut down the boiler
at once. Find the leak source
with bubble test and repair im-
mediately. Do not start boiler
again until corrected. Failure
to comply could result in se-
vere personal injury, death or
substantial property damage.
Eliminate all system leaks.
Continual fresh makeup water
will reduce boiler life. Miner-
als can build up in sections,
reducing heat transfer, over-
heating cast iron, and causing
section failure.
Glycol or antifreeze leaks
around the boiler may result
in fire, causing severe personal
injury, death or substantial
property damage.
petroleum-based
Do not use
cleaning or sealing com-
pounds
in boiler system.
Severe damage to boiler will
occur, resulting in substantial
property damage.
Venting system must be sealed
gas-tight to prevent flue gas spill-
age and carbon monoxide emissions
which will result in severe personal
injury or death.
for gas odor following the
7a
of this manual.
7b
per Section . Perform check-out
8 Installation
, and fill in the
on the same page.
Part Number 550-110-710/1211