Iwatsu ADIX-VS Technical Manual page 98

ADIX-VS Technical Manual
11. Step 2: ADIX Database Programming
1. Step 2 is required for all VS-VML card installations.
2. Enter ADIX database programming mode. Go to Class 04 Item.77 and program each
DTMF packet. (Suggested Class 04.77 settings are listed in the table on the next page.)
3. Program Class 04.71 <NUM14> to equal 2. This programs the ADIX to send the calling
extension and Caller ID/ANI (if used) to Omega-Voice VMI (Software Version
4.71/5.71, ACD 2.31 and higher only). If trunk information is also required, set this
item to equal 5.
4. Required. Go to Class 04 Item 71 <NUM13> and program the disconnect signal type
for voice mail ports to equal 1 (disconnect by loop open).
5. Go to Class 04 Item 71 <NUM15> and program the loop open duration for voice mail
ports to equal 7 (700 milliseconds).
6. Class 07 Item 02 — "Hunting Group Access Number" and assign an access code for
hunt group 47.
7. Class 07 Item 06 — "Feature Access Number" and assign an access code for the following:
S
<NUM01> - Cancel Code (e.g., 501)
S
<NUM19> - Activate Message Lamp (e.g., 519)
S
<NUM48> - Voice Mail Access Number for Transfer or Direct Mailbox Access (e.g., *)
7. Go to Class 08 Item 02 — "Hunt Group Station" and assign all station logical ports defined as
voice mail ports to Hunt Group 47.
8. Recommended Programming: Setup the Attendant All Call feature in Class 04 Item 55 and Class
07 Item 06 <NUM30>.
Programming Background Music
The ADIX-VS System provides a background music(BGM) interface to external P.A.system speakers
and KT station speakers.
Play BGM Through All KTs
)
Programming and Conection:
1. Access the programming mode from a programming KT,or PC Programmer Software. Go to
Clase 04 Item 03-BGM Input Port.
2. Connect the BGM source output to the punchdown block as illustrated in Figure 40.
3. Turn potentiometer VR1 on the VS-MISC to adjust the BGM volume. Clockwise to increase,
counterclockwise to decrease.
4. Connect the output from the punchdown block to one quick-connection type connector on the
VS-MISC card.
5. Press [FEAT]+[6][2] from a KT to turn on BGM. Press [FEAT]+[0][6][2] to turn off BGM.
Section 3 – ADIX-VS Installation
88