Iwatsu ADIX-VS Technical Manual page 66

ADIX-VS Technical Manual
Overview of LEDs and Switches
Hook LED
This LED is the primary hook switch status indicator. This LED does not provide indication when
IX-COMLINK is ringing.
Status
ON IX-COMLINK is busy, off-hook on a conversation.
OFF IX-COMLINK is idle or ringing.
Mode LED
This LED provides audio status indication. It only functions when the Hook LED is lit.
Status
OFF
SOLID
SLOW FLASH
FAST FLASH
Switch 1-8 (Not Used)
Switches 1-8 must remain in the OFF position (factory setting).
PC Interface
There are three possible interfaces between PC and IX-COMLINK:
The PC serial interface.
The audio interface.
The modem interface.
PC Serial Interface. This is the primary connection between the IX-COMLINK and your computer.
The PC serial interface is used to send control data between the PC and the IX-COMLINK.
Audio Interface. If a sound card is connected to the IX-COMLINK LINE IN jack, a device driver is
required to control audio through the sound card. This device driver is supplied by the sound card
and/or computer telephony application manufacturer. The computer telephony application software
must also support this capability. These drivers are not included with the IX-COMLINK Installation
Disk.
Modem Interface. A device driver is required to control the PC modem. Iwatsu recommends using
Unimodem (/V) if the application uses TAPI for controlling the modem. Also for controlling the
modem, the application must use a driver which supports the modem. Unimodem (/V) is included
with Windows® 95 or available from Microsoft Corporation.
Description
Digital Key Telephone is in use.
IX-CTC/H Handset/Cradle or Headset connected to HEADSET jack is in use.
Microphone connected to PC Sound Card is in use. (0.8 sec. On / 0.2 sec. Off)
Modem is in use. (0.1 sec. On / 0.1 sec. Off)
56
Section 2 – ADIX-VS Hardware
Description