Database Programming - Iwatsu ADIX-VS Technical Manual

ADIX-VS Technical Manual
Installation
1. Loosen the two screws on each side of the card stopper bracket and slide the card stopper bracket
down approximately ¼" in order to clear the circuit cards.
2. Plug the card into any trunk interface card slot. Make sure that the card is inserted deep enough
for all connector pins to make complete contact with those on the motherboard (VM-MAIN).
3. Secure the FG bracet on the card with a screw.
4. Secure the card stopper bracket on the motherboard(VS-MAIN) with the four screws if no other
cards are to be installed.
MDF Connections
VS-2CITK Port Assignment
Card Slot 1
Circuit
1
2
Card Slot 2
Circuit
1
2
Card Slot 3
Circuit
1
2

Database Programming

Required Database Items: 01.03 Port Definition;01.04 Configuration;01.07 Number of System Trunk
Ports;11.08 Dial Type(DP or DTMF);11.09 DTMF Dial Speed;11.11 Dial Pulse Speed;11.12 Dial
Pulse Break Ratio;Class 24 Caller ID/ANI Conversion Data.
Modular
CITK Jack Number Wire Color
1T 1, 3, 5
1R
2T 2, 4, 6
2R
Physical Port Logical Port Number
065 Trunk Logical 010
066 Trunk Logical 011
Physical Port Logical Port Number
067 Trunk Logical 012
068 Trunk Logical 013
Physical Port Logical Port Number
069 Trunk Logical 014
070 Trunk Logical 015
CM RJ11 Jack
Pin Number
W-BL 3
BL-W 2
W-GN 3
GN-W 2
74
Section 3 – ADIX-VS Installation
Wire Color
GN
R
GN
R