Starting And Stopping; Assembly Instructions - Flymo easibag Instructions Manual

A
Lower Handle Assembly (A)
1. Lift the grassbox lid and remove the grassbox.
2. Insert the lower handle into the handle slots,
ensuring that the holes are aligned.
3. Insert the pins and secure with the retaining clips (A1).
4. Replace the grassbox, and lower the grassbox lid
carefully.
C
D
F
H
J

Assembly Instructions

1
How to Fit the Bag
Fit bag

Starting and Stopping

E
G
1
B
1
Upper Handle Assembly (B)
1. Insert the nut into the handle knob (B1).
2. Align the holes in the upper and lower handles and
secure with the bolt, washer and wing knob (B2).
3. Fit the cable to the handle with the clips provided
(C3). Make sure the cable is not trapped
between the upper and lower handles.
Using with the Bag (C)
1. Lift the grassbox lid. The grassbox will turn into
an upright position.
2. Insert the bag into the grassbox. Secure the bag
by turning the edges over the rim of the grassbox,
as indicated on the bag.
3. Lower the grassbox lid carefully. Do not drop.
4. Make sure that the grassbox lid is closed correct-
ly, ensuring that there is no grass trapped
between the grassbox lid and the hood.
• Please note, this product can be used with or
without the bag.
To Start your Lawnmower
Your lawnmower uses an advanced belt drive system,
between the motor and the blade which improves cutting
power and flotation in all conditions. Due to the high turning
force (Torque) which this motor develops a light squeak
may be heard when the machine is started, this is quite nor-
mal and will not effect the performance of the product
1. Connect female extension cable connector to the
back of the switchbox. (D)
2. Form loop in mains cable and push the loop through
the slot as illustrated in picture (E)
3. To secure, position loop over the hook and pull the cable
back through the slot as illustrated in picture (F).
4. Connect plug to mains and switch on.
5. To prevent a ring being cut in your lawn and to clear
any residual grass in the collection chute, tilt your
lawnmower slightly (G).
The switchbox is provided with a lock-off button
(H1) to prevent accidental starting.
6. Press and hold the lock-off button (H) on the switch-
box, then squeeze one of the Start/Stop levers
towards the upper handle (J).
7. Continue to squeeze the start/stop lever towards the
upper handle and release the lock-off button.
8. When the lawnmower has reached full speed gently
lower it onto the lawn.
NOTE: There are two start/stop levers fitted. Either
one can be used for starting the lawnmower.
IMPORTANT : Do not use the start/stop levers intermittently
To Stop your Lawnmower
1. To prevent a ring being cut in your lawn and to clear
any residual grass in the collection chute, tilt your
lawnmower slightly (G).
2. Release the pressure on the Start/Stop lever.
2
3