Brick Replacement; Blower Installation And Operation - Quadra-Fire 2100 Millennium Owner's Manual

1. After the coals have completedly cooled, remove all old brick
and ash from unit and vacuum firebox.
2. Remove new brick set from box and lay out to diagram shown.
3. Lay bottom bricks in unit.
4. Install rear bricks on the top of the bottom bricks. Slide top
of bricks under clip on back of firebox wall and push bottom
of brick back.
5. Install side bricks. Slide top of brick under clips on side of
firebox and push the bottom of the brick until it is flush with
the side of the unit.
Nbr Brick Size
1 9.0" x 4-1/2" x 1-1/4"
2 9.0" x 2-1/2" x 1-1/4"
3 7.0" x 4-1/2" x 1-1/4"
4 7.0" x 4-1/2" x 1-1/4"
(with hole)
5 6-3/4" x 4-1/2" x 1-1/4"
INSTALLATION OF OPTIONAL BLOWER, Part 831-1701
1. Remove the three bolts (1/4"-20 Phillips Head) on the outer skin at the bottom rear of stove.
2. Align holes in mounting flange of blower with bolt holes in stove. Blower should be positioned around bottom of rear outer skin
as shown in drawing below.
3. Reinsert and tighten bolts, securing blower onto outer wall of stove.
Do not remove ground from plug. Plug blower cord into a grounded outlet. Route power cord away from stove in such a
manner to avoid heat from the stove, traffic, or other damage. Do not route cord under or in front of stove.
ADJUSTING THE BLOWER SPEED CONTROL, IF NECESSARY*
*The blower speed control for this unit is
adjusted at the factory, and normally does
not require further adjustment.
NOTE: When the speed control is turned clockwise, it
will click on to high speed. Continue to turn the
speed control clockwise to decrease the speed. At
full clockwise, the blower should blow gently, but
should not stop.
1. With the unit plugged in, turn the speed control knob
to slow (full clockwise).
2. With a small screwdriver, adjust the blower speed by
turning the adjustment mechanism through the hole
on the side of the speed control.
3. Adjust the speed so the blower runs slowly, but does
not stop. Turn clockwise to slow the blower and
counterclockwise to increase the speed.
250-6931C November 3, 2004
2100 ACT Millennium Wood Stove
BRICK REPLACEMENT INSTRUCTIONS
Brick Set Part 831-1890
Qty in Set
12
3
1
1
1
The blower is shipped fully assembled and ready for installation.
1
2
1
1
1
Use Part 832-0550 when ordering individual brick. Provide
brick dimension or copy this page, mark the desired brick and
take it to your authorized dealer.
BLOWER SPEED CONTROL
Outer
Blower
Skin
Mounting
Flange
3
1
2
4
1
1
1
1
1
1
1
5
2
R
Page 19