Accesssory / Parts Replacement Outside Air Kit - Quadra-Fire 2100 Millennium Owner's Manual

R
Included in Kit: 1 front cover; fiberglass rope; 2 vent straps; venting flange & 4 screws; termination cap & screws. Discard
the 2 side covers and 1 rear cover as they are not needed for your Quadra-Fire 2100 Millennium.
Items Needed for Installation: 4" flex pipe in the length as required for your installation; Phillips screwdriver; Silicone
sealant; Drills and saws necessary for cutting holes through the wall or flooring in your home.
1. Remove all materials from packing box.
2. Using a #2 Phillips screwdriver, remove 2 bolts beneath the ashcatcher. Reuse bolts to install front cover. Be certain
that the cover is pushed back as far as possible.
3. Floor installation: Cut a 4" (102mm) minimum hole in the floor to accommodate outside air piping. Use 4" (102mm)
metal flex or rigid piping to directly connect outside air to the unit or into vented crawl space. (Do not put flex into a
non-vented crawl space). Use the supplied termination cap with a rodent screen. Seal between the floor and the pipe
with silicone to prevent moisture penetration. Install fiberglass sealing rope under each side of pedestal.
4. Rear/wall installation: Use the knockout plate in rear of the pedestal for exterior wall venting. Cut a 4" (102mm) hole in
outside wall to accommodate outside air piping. Use 4" (102mm) metal flex or rigid piping to directly connect outside air
to stove intake. Use the supplied termination cap with a rodent screen. Seal between the wall and the pipe with silicone
to prevent moisture penetration. Install fiberglass sealing rope under each side of pedestal.
FRONT COVER
Page 14
2100 ACT Millennium Wood Stove
OUTSIDE AIR KIT INSTALLATION
Part 831-1780
FIBERGLASS SEALING ROPE
4" (102mm)
FLEX LINE
(Not Included)
FLEX FLANGE
(if needed for rear exit)
C L
3-3/8" (86mm)
OUTSIDE AIR
TERMINATION CAP
(contains rodent screen)
250-6931C November 3, 2004