Place The Patterns In The Pattern Track - Yamaha SY77 Operating Manual

Editing functions in song mode allow you to place previously created patterns into track 16 (the pattern
track) for use as rhythm parts or for phrases which appear frequently.
Chain Pattern mode
Using repeat marks
Input the data for each
part
40

Place the patterns in the pattern track

Before recording the other tracks, we will place the previously recorded patterns
into track 16. Press
select track 16 (the pattern track) for editing. While editing track 16 you will be
in Chain Pattern mode.
In this example, we will chain patterns so that three measures of the basic
rhythm are followed by a fill-in, and make this four-measure chain repeat for
eight times. Although is is possible to input all 32 parts (the four-measure chain
× 8 times), it is more efficient to use repeat marks. To do this we will input data
for each part as follows.
Part 001 : II:
Part 002 : 01
Part 003 : 01
Part 004 : 01
Part 005 : 02
Part 006 : :II × 7
Move the cursor to the right and press
part 001, then press
Select pattern "01w" for Part 002, and press
In the same way input pattern 01 for parts 003 and 004, and pattern 02 for
part 005.
For part 006, press
parts between the begin and end repeat marks repeat 7 times. Be sure to press
to enter each part.
ENTER
When you are finished editing the chain of patterns, press
Song Play mode. Press
and then to enter song edit mode. Press 16 to
SONG EDIT
(II:) to enter a repeat begin mark for
F2
. The "Part" display will advance to 002.
ENTER
(:II). Use –1 +1 to specify " × 7" so that the range of
F3
and you will hear the newly edited chain of patterns.
RUN
.
ENTER
EXIT
to return to