Micro Tuning - Yamaha SY77 Operating Manual

VOICE EDIT MODE
40:Ind. Reverb & Delay
Lch Reverb Time (0.3... 10.0 sec)
Rch Delay Time (0.1... 152 ms)
Rch Feedback Gain (0...99%)
Reverb effect parameters: The parameters of the
reverb effects are explained below in alpha-
betical order.
Brilliance: the overall brightness of the sound
Delay Time: the delay before the echoed sound
Direction: the direction in which the echoes will
be panned
Dist & Rev Balance: the balance between dis-
tortion and reverb
Distortion Level: the amount of the distorted
sound
FB Delay Time: the delay between repeated
echoes of the sound
Feedback Gain: the volume ratio of each echo to
the previous one
H.P.F.: frequencies higher than this will be
allowed to pass
High Control: the proportion at which high
frequency reverb will decay
High Gain: the amount of boost or cut at 3 KHz
Initial Delay: the delay before the effect pro-
cessed sound will be heard
L.P.F.: frequencies lower than this will be
allowed to pass
COMMON DATA
Summary: Select a micro tuning for the entire voice,
and specify whether or not each element will use
this micro tuning.
Procedure:
From: Voice Common job
directory
Select: job 11 :McrTune
Specify: the micro tuning, and element micro tun-
ing on/off
106

11. Micro tuning

(JUMP #201)
(JUMP #221)
Lch Brilliance: the overall brightness of the left
channel
Lch Delay Time: the delay between repeated
echoes in the left channel
Lch Dist. Level: the amount of distortion for the
left channel
Lch Feedback Gain: the volume ratio of each
successive left channel echo
Lch Reverb Time: the time for the left channel
reverb to decrease 60 dB
Low Gain: the amount of boost or cut at 800 Hz
Mid Gain: the amount of boost or cut at 1260 Hz
Pre-Delay Time: the time delay before reverb
will begin
Rch Brilliance: the overall brightness of the right
channel
Rch Delay Time: the delay between repeated
echoes in the right channel
Rch Dist. Level: the amount of distortion for the
right channel
Rch Feedback Gain: the volume ratio of each
successive right channel echo
Rch Reverb Time: the time for the right channel
reverb to decrease 60 dB
Reverb Time: the time for the reverb to decrease
60 dB
Room Size: the size (in arbitrary units) of the
reverberant room
Micro Tuning Select (I-1, I-2, C-1, C-2, P-1...
P-64): Select a micro tuning to be used by the
voice. 64 micro tuning memories are preset
inside the SY77 (see the following remarks).
Two of your own micro tunings can be stored in
Internal memory, and a card can accommodate
another two micro tunings. Internal voices can-
not use card micro tunings, nor can card voices
use internal micro tunings.
Element 1-4 (off, on): When this is turned on,
the element will use the micro tuning selected by
Micro Tuning Select. When this is turned off, the
element will use equal temperament scale
instead of the selected micro tuning.
JUMP #221