Voice Name; Initialize Voice - Yamaha SY77 Operating Manual

VOICE EDIT MODE
DRUM SET DATA
Summary: Specify a ten-character name for the
voice being edited. In voice play mode this voice
name will be displayed in large characters.
Procedure:
From: drum set job directory
Select: 05:Drum Set Name
Specify: the drum voice name
DRUM SET DATA
Summary: Initialize the drum set data being edited
to the basic or minimum settings.
Procedure:
From: drum set job directory
Select: 07:Initialize
To execute: the initialize operation press YES
To quit: without executing press NO or EXIT
This function sets all drum set data to the basic or
minimum settings. If you are creating an entirely
new voice, using this initialize function may be
faster than resetting all the parameters by hand.
If you are sure you want to initialize the drum set
data press YES and the data will be set to the values
shown below. If you decide not to initialize, press
NO.
152

5. Voice name

(JUMP #272)
(JUMP #229)
For a detailed explanation of how to enter character
data, refer to How to enter data of the Introductory
manual.

7. Initialize voice

Other initialize functions are provided for initializing
Voice Common data, AFM Element data, or AWM
(JUMP #271) Element data.
Initialized settings for Drum Set data
01 Voice volume
02 Wave data set (for each Key Note Number)
Enter a ten-character name for the drum voice.
To clear the currently entered name press F1
(Clr). To switch to upper-case characters press
F2 (Uppr). To switch to lower-case characters
press F3 (Lowr).
This function initializes only Drum Set data.
Voice volume = 127
Level = 127
Output Group = both
Fine tuning = ±0
Alternate = off (all key note numbers
(all key note numbers)
(all key note numbers)
(all key note numbers)
except A2 HI-HAT
CLOSED and B2 HI-
HAT OPEN)