Bulk Dump - Yamaha SY77 Operating Manual

Program change = direct: This allows any voice or
multi memory to be selected using program
changes. Program changes 0-116 will be
received and transmitted just as in "normal".
Transmission: If you select a voice or multi after
changing the memory (internal, card, preset 1, or
preset 2) or mode (voice or multi), one of the
following program changes 117-127 will be
transmitted to indicate the newly selected
memory or mode. Immediately following this will
be the program change of 0-63 or 64-79 to indi-
cate the newly selected voice or multi.
Reception: Incoming program changes 117-124
will select a voice memory, and must be imme-
diately followed by a program change 0-63 to
select the voice number. Incoming program
changes 125-127 will select a multi memory, and
must be immediately followed by a program
change 64—79 to select the multi number.
Incoming program changes 119 and 120 are
not distinguished, since a internal multi is not
allowed to use card voices, nor vice versa.
MIDI UTILITY
Summary: Various types of SY77 data can be
transmitted via MIDI to another SY77 or other
device.
Procedure:
From: MIDI utility job
directory
Select: 03:Bulk
Specify: the type of data to be transmitted
To execute: data transmission press F8 (Go).
To quit: without executing press EXIT.
Move the cursor in the area to select the type of
data you wish to transmit. Then press F8 (Go).

3. Bulk dump

(JUMP #806)
D u m p (JUMP #809)
No. Mode
117 Voice mode
1 1 8 Multi mode
1 1 9 Multi mode
120
Multi mode
121 Multi mode
122 Voice mode
123 Voice mode
124 Voice mode
125 Multi mode
126 Multi mode
127 Multi mode
01: Vc & Mlt: All internal voice, multi, pan, and
micro tuning data
02: Syn Setup: System setup data for the syn-
thesizer section
03: Pan: All internal pan data
04: McrTuning: All internal micro tuning data
05: 64 voices: All internal voices
06: 16 Multis: All internal multis
07: 1 Voice: A single specified voice
08: 1 Multi: A single specified multi
09: Seq All: All data of the sequencer section
10: Song&Ptn: Song and pattern data
11: Seq Setup: Setup data of the sequencer
section
12: NSEQ: Sequencer data in N-Seq format
Go: When you press F8 (Go) transmission will
begin and the bottom line of the LCD will display
"Now transmitting !" When transmission ends
the bottom line will display "Complete !"
UTILITY MODE
Type Memory
Voice Preset 2
Voice Preset 2
Voice Internal
Voice Card
Preset 1
Voice
Voice Internal
Voice Card
Voice Preset 1
Multi Internal
Multi Card
Preset
Multi
JUMP #809
223