Copy Voice Effect; Fl) Modulation Effect 1 Set (Data) - Yamaha SY77 Operating Manual

VOICE EDIT MODE
COMMON DATA / EFFECT SET
Summary: This function copies Effect data from
another voice into the effect data of the currently
edited voice.
Procedure:
When: editing Effect data (jobs 10.1-10.5)
Press: COPY to get the following display.
Specify: the voice from which to copy the effect
data
To copy: the data press F8
To quit: without copying press EXIT
COMMON DATA / EFFECT SET
Summary: Select an effect type for modulation effect
1, and set the effect balance and output level.
This explanation also applies to modulation
effect 2.
Procedure:
From: Effect Set job directory
Select: 02:Modulation Effect 1 Set
Press: F1 (Data)
Specify: the effect type, effect balance, and output
level
Effect Type: Four types of effect can be selected
for the modulation effect unit. Refer to the list of
modulation-type effects in the following section
10.2 (F2).
Effect Balance (0...100%): This determines the
balance of processed and unprocessed sound. At
a setting of 0% the output of the effect unit will
be only unprocessed sound, and at a setting of
100% the output of the effect unit will be only
processed sound.
102

10.1.1 Copy voice effect

10.2 (F1) Modulation effect 1 set (Data)
(JUMP #211)
(JUMP #213)
Use the voice memory buttons, bank buttons A-
D, and voice memory buttons 1—16 to select a
source voice from which to copy the Effect data.
Press F8 (Go) and you will be asked "Are you
sure?". If you are sure you want to copy the
effect data, pressYES and the effect data will be
copied from the selected voice to the voice being
edited.
Output Level (0...100%): This determines the
volume level of the effect output. At a setting of
0% the effect unit will output no sound, and at a
setting of 100% the output of the effect unit will
be at full volume.
To set the parameters of the selected Effect
Type, press F2 (Parm). (See the following sec-
tion 10.2 (F2).)
Remarks: All modulation effects are stereo-in
stereo-out.
Note: Changing the Effect Type will initialize the
Parameter settings of F2 (Parm).
JUMP #213