Louver Installations With Typical Unit Configurations; Unit Configuration Type Al - Daikin AVS Installation Manual

Louver Installation With Typical Unit Configurations

Unit Configuration Type AL

Figure 9 - The 16 " (422mm) Deep Unit with Open Pipe Tunnel and
5
/
8
Standard Louver Location
Lintel
(By Others)
Louver
Sealed Cement
Mortar;
Pitch Away
From Unit
Unit Configuration Type AL
Figure 11 - Above Floor Level Outdoor Air Intake Using Arrangement
AV or AL With Accessory Closed Pipe Tunnel
Lintel (By Others)
Insulated Closure
Plate Accessory
Intake Louver
Not Less Than 3"
Not More
Than 28"
Sealed Cement
Mortar;
Pitch Away
From Unit
Provide
Drainage
Page 8 of 60
Piping
1"
(25mm)
Floor Line
Important: Gasket sealing
surface is required.
Accumulated moisture can cause property damage if not properly
drained. Installing contractor must provide such drainage.
Piping
1"
(25mm)
Floor Line
Important: Gasket sealing
surface is required.
Figure 10 -16 ⁄ " (422mm) Deep Unit with Open Pipe Tunnel & High
5
8
Louver Application with Chased Wall
Lintel
(By Others)
Louver
Not Less
Than 3" (76mm)
Not More
Than 21" (533mm)
Sealed Cement
Mortar;
Pitch Away
From Unit
Provide Drainage
CAUTION
Figure 12 - Floor Level Outdoor Air Intake With Window Below Unit
Top Using Arrangement AL And 9˝ "Finished" (Painted) Accessory
(Uninsulated) Closed Pipe Tunnel
Painted Insulated Closure Plate Accessory
Sash
Lintel (By Others)
Intake Louver
Sealed Cement
Mortar;
Pitch Away
From Unit
Piping
1"
Floor Line
(25mm)
Important: Gasket sealing
surface is required.
Piping
1"
(25mm)
Floor Line
Important: Gasket sealing
surface is required.
IM 817-4