Table of Contents
Advertisement
6. INSTALLATION INSTRUCTIONS
A. PRECAUTIONS
! DANGER
IMPROPER INSTALLATION MAY DAMAGE
EQUIPMENT, COULD ENDANGER LIFE,
CAUSE SERIOUS INJURY AND/OR
PROPERTY DAMAGE.
12.7"
3105975 AIR
34.4"
DISTRIBUTION
BOX
19-3/4"
3107209 AIR
DISTRIBUTION
BOX
KEEP THIS AREA FREE OF OBSTRUCTIONS
5-3/8
14-1/4" X 14-1/4"
OPENING
3105975
AIR DISTRIBUTION BOX
FRONT
3-1/8"
14-1/4" X 14-1/
19-3/4"
4"
OPENING
4-1/8"
4-1/8"
2-5/8"
11-1/8"
11-1/8"
29.5"
22-1/4"
2-1/2"
7-3/4"
REAR
15"
OF
UNIT
7-3/4"
18"
3107209
AIR DISTRIBUTION BOX
14" x 14"
OPENING
1) Read Installation and operating instructions care-
fully before starting your air conditioner installa-
tion.
2) The Dometic Corporation will not be liable for any
damages or injury incurred due to failure in follow-
ing these instructions.
3) Installation must comply with the National Electri-
cal Code and any State or Local Codes or regula-
tions.
4) DO NOT add any devices or accessories to this air
conditioner except those specifically authorized
by Dometic.
5) This equipment must be serviced by qualified
personnel and some states require these people
to be licensed.
B. CHOOSING LOCATION FOR
THE AIR CONDITIONER
This air conditioner is specifically designed for instal-
lation on the roof of a recreational vehicle (RV).
1) NORMAL LOCATIONS:
The air conditioner is designed to fit over an
existing roof vent opening. When the vent is
removed, it normally creates a 14" x 14" open
ing.
2) OTHER LOCATIONS:
When no roof vent is available or another
location is desired, the following is recommended:
For one unit installation: The air conditioner
should be mounted slightly forward of center
(front to back) and centered from side to side.
For two unit installations: Install one air
conditioners 1/3 and one air conditioner 2/3's
from front of RV and centered from side to side.
It is preferred that this air conditioner be installed in a
relatively flat and level roof section measured with the RV
parked on a level surface; however,
a) Up to a 15° slant to either side or front-to-
back is acceptable on 591 Series Heat
Pumps.
3) AFTER LOCATION SELECTION:
a) Check for obstructions in the area where air
conditioner will be installed.
b) The roof must be designed to support 130
pounds when the RV is in motion. Normally a
200 lb. static load design will meet this require-
ment.
c) Check inside the RV for air box obstructions.
(i.e. door openings, room dividers, curtains,
ceiling fixtures, etc.)
4
Hide quick links:
Advertisement
Table of Contents
