Edimax BR-6224n Usre Manual page 61

Field
Cwmax
Txop
ACM
Ackpolicy
- DLS (Direct Link Setup)
BR-6224N provides DLS function. Suppose that there are two WMM devices. Enter
the MAC address of a WMM device in the DLS setting of the other device, and then
connect the two WMM devices to the BR-6224N. In this way, these two WMM
devices can transmit message directly.
If you want to configure WMM DLS, do as follows:
Step1 Prepare two wireless network cards (A and B) and one BR-6224N.
Step2 Enable the DLS function on the Advanced Wireless Settings page.
Step3 Enable the DLS function of wireless network cards. Enter the MAC address
of wireless card A on the WMM page of the wireless network card B, and
smaller, but the difference between AC_BE and
AC_BK should be bigger.
Cwmax (Max.Contention Window)
Txop (Opportunity to Transmit) may optimize the
WMM access. Compared to the WMM access that
needs a higher priority, such as AC_VI and AC_VO,
this value should be bigger.
ACM (Admission Control Mandatory) parameter
only reacts on AC_VI and AC_VO. If you set this
value to be 0, it indicates that AP is in the charge of
the access commands. If this value is 1, it means
the client is in the charge of the access commands.
When WMM packets are transmitting, AP will
receive an echo request. If you set this value is 0, it
means AP does not send back an echo request,
which will bring positive effect for WMM. If this value
is 1, AP generates the response to the request.
55
Description