Variquest Poster Maker 3600 User Manual page 63

Problem
The printed poster is blank.
The poster is printed as a mirror
image of the original.
Printed images or text are
excessively thin or light or
excessively dark.
The Poster Maker paper roll is
too tight or too loose in the
brackets.
The printed poster does not
come out of the printer.
The printer does not start
printing after you press
[Start/Stop].
A document jam occurs.
A black band appears on the
back of the print.
The ink sheet on TTP or HDP
paper has a lot of wrinkles in it.
White bubbles appear on the
printed surface of TTP or HDP
paper.
The printing process is
unexpectedly slow. (A "Slow
Mode" message appears in the
display.)
®
VariQuest Poster Maker 3600 User's Guide
Ensure that the Poster Maker paper roll has been
installed properly.
Ensure that the original was placed face down in the
document bay.
Change the Mirror Print setting to Off.
Set the contrast level to a darker or lighter position.
If the images or text on the original are too light or dark,
use a better copy of the original, if possible.
Check that the type of paper indicated in the display
matches the type of paper that is installed.
Poster Maker paper rolls can expand or shrink with
changes in humidity. Loosen the adjustment knob and
move the left paper bracket until the paper roll can be
installed properly, or install a new paper roll.
Open the printer cover and check if the paper is caught in
the paper feed rollers.
Ensure that the printer cover is closed properly.
Be sure you have placed the original into the scanner until
it stops.
The printer will not scan transparent documents. Copy the
original onto plain paper and try again.
Check if there is an error message in the display.
Open the scanner cover and remove the original. Close
the scanner cover and try again.
If a document jam occurs again, be sure the original has
been placed in the scanner properly.
A black band is printed on DTP paper to indicate that the
paper roll is nearly empty. Change the paper roll when the
band appears.
Check that the type of paper indicated in the display
matches the type of paper that is installed.
Check that the type of paper indicated in the display
matches the type of paper that is installed.
The printer automatically switches to a slower speed
when the thermal heads overheat. This typically occurs
when printing posters with large black areas or when
printing in reverse mode. This is normal and does not
indicate an error in the printing process.
Solution
Troubleshooting
Page #
3-2
3-7
4-2
3-13
--
--
3-2
--
--
3-7
--
3-7
3-7
3-7
--
--
--
3-11
5-5