Adjusting The Drive Chain Slack - Yamaha T135SE Service Manual

BLEEDING THE HYDRAULIC BRAKE SYSTEM/

ADJUSTING THE DRIVE CHAIN SLACK

http://www.motorcycle.in.th
NOTE:
Loosening the bleed screw will release the pres-
sure and cause the brake lever to contact the
throttle grip.
h. Tighten the bleed screw and then release
the brake lever.
i. Repeat steps (e) to (h) until all of the air
bubbles have disappeared from the brake
fluid in the plastic hose.
j. Tighten the bleed screw to specification.
Bleed screw
6 Nm (0.6 m·kg, 4.3 ft·lb)
k. Fill the brake master cylinder reservoir to
the proper level with the recommended
brake fluid.
Refer to "CHECKING THE BRAKE FLUID
LEVEL".
w
After bleeding the hydraulic brake system,
check the brake operation.
EAS00140
ADJUSTING THE DRIVE CHAIN SLACK
NOTE:
The drive chain slack must be checked at the
tightest point on the chain.
cC
Adrive chain that is too tight will overload
the engine and other vital parts, and one that
is too loose can skip and damage the
swingarm or cause an accident. Therefore,
keep the drive chain slack within the speci-
fied limits.
3-32
CHK
ADJ