Control Panel - Troy-Bilt Portable Generator Operator's Manual

Control Panel

Read this Operator's Manual and safety rules before operating your generator.
Compare the illustrations with your control panel, to familiarize yourself with the locations of various controls and
adjustments. Save this manual for future reference.
A
B
C
D
E
F
G
A - 120 Volt AC, 20 Amp, Duplex Receptacles — May be
used to supply electrical power for the operation of
120 Volt AC, 20 Amp, single phase, 60 Hz electrical,
lighting, appliance, tool and motor loads.
B - On/Off Switch — Set this switch to on (I) before starting
engine. Set switch to off (O) to shut off engine.
C - Battery Float Charger Jack — Use battery float charger
jack to keep the starting battery charged and ready for use.
D - Display Button — Push to scroll through LCD screens
on Extend-a-panel™. Also push and hold for a minimum
of 3 seconds to reset maintenance reminders and
security features.
E - Choke Control — Used when starting a cold engine.
F - Start Switch — Push and hold in "Start" position for a
maximum of 5 seconds during each start attempt, until
engine starts.
12
G - Circuit Breakers (AC) — The 120 Volt AC, 20A duplex
receptacles are provided with "push to reset" circuit
breakers to protect the generator against electrical
overload.
H - Rocker Switch Main Circuit Breaker — The
120/240 Volt AC, 30A locking receptacle is provided with
a rocker switch circuit breaker to protect generator
against electrical overload.
J - 120/240 Volt AC, 30 Amp Locking Receptacle — May be
used to supply electrical power for the operation of
120 and/or 240 Volt AC, 30 Amp, single phase, 60 Hz
electrical, lighting, appliance, tool and motor loads.
K - Rocker Switch Cordset Circuit Breaker — The cordset
on main panel is provided with a double pole rocker
switch circuit breaker to protect generator against
electrical overload.
K
J
H
troybilt.com