Operating Instructions; Heater Operation; Operating Sounds And Smells; Starting A Fire - Napoleon High Country NZ3000 Installation And Operating Instructions Manual

30

7.0 OpErATiNg iNSTruCTiONS

Expansion / contraction noises during heating up and cooling down cycles are normal and to be expected.
tIPS FOR BURNING:
• Create a large fire to heat up the fireplace before adjusting to a slower burn.
• To create a large, quick burning fire, use small pieces of wood.
• For a lower, but extended burn, stack larger pieces of wood close together.
• For long burns, leave a 1-2" bed of ashes.
• Burn dry wood only.
• With the exception of overnight burns, create large, quick burning fires whenever possible. Smaller, slow burning
fires, using large logs, cause the glass to become dirty. Larger, quick burning fires using medium sized wood to
refuel frequently are much more efficient.
7.1

HEATEr OpErATiON

Primary combustion air enters through the air control inlet box regulated by a draft control, travels up the side
through a duct and enters the top centre of the combustion chamber into a preheating airwash located across
the top and then down the window to feed the fire and also to ensure that the glass remains clean.
Secondary air feeds directly into the combustion chamber at hearth level then travels to the secondary air
chamber and shoots out to oxidize the gases rising to the smoke exit.
7.2

OpErATiNg SOuNdS ANd SmELLS

A slight humming sound may be heard depending on the location of the blower. This sound may be
minimized by turning down the blower speed.
When first installed, the fireplace and the steel are cold and must become hot before the fireplace will function
well. During the break-in period (the first 2 or 3 fires) create only small, hot fires using kindling; this will allow
the firebrick to cure. Do not be alarmed if small hairline cracks develop in the firebrick. This is a normal
occurrence and does not pose a safety hazard. The paint may also smell a little for the first few fires as it
cures and you may wish to open a door or window to alleviate the smell.
There are many different ways to start a fire, review the hints and warnings in this section to ensure the fire is
started properly.
7.3

STArTiNg A FirE

Always operate this appliance with the door closed and latched except during start up and re-fueling
or when using the spark screen. Always wear gloves to prevent injury. Do not leave the fire unattend-
ed when the door is unlatched or when using a spark screen as unstable wood could fall out of the
Never leave children unattended when there is a fire burning in the fireplace.
Make sure the air control lever is on high (far left position). You may also open the doors 1" to 2" during the first
five minutes of start-up, if additional air is needed see "COMBUSTION AIR" section.
Never use gasoline, gasoline-type lantern fuel, kerosene, charcoal lighter fluid, or similar liquids to start or
freshen-up a fire in this fireplace. Keep all such liquids well away from the fireplace while it is in use.
If using a firestarter, use only products specifically designed for fireplaces - follow the manufacturer's
instructions carefully.
Remove all source of gasoline or other flammable vapours and liquids in the vicinity of this or other
appliances prior to lighting.
Use plenty of newspaper and kindling to ensure the fireplace reaches a proper temperature. Once the kindling
is burning rapidly, place a few larger pieces of wood onto the fire.
Tip: When first lighting a fire, if the smoke is not quickly drawn into the chimney, there may be a downdraft or
cold air in the chimney. By first burning large amounts of crumpled newspaper, the chimney will get heated and
the smoke will quickly vent up the chimney.
W415-0711 / 10.03.08
fire chamber creating a fire hazard to your home.