Installation Planning; Location And Clearances - Napoleon High Country NZ3000 Installation And Operating Instructions Manual

3.0 iNSTALLATiON pLANNiNg

3.1

LOCATiON ANd CLEArANCES

Do not install into any area having a height less than 7 feet (ceiling of enclosure to fireplace bottom,
ImPORtANt
This fireplace, fully dressed, weighs 575 lbs. Ensure there is adequate floor support for the fireplace, chimney
and finishing material. Some material could weigh thousands of pounds.
We recommend that the fireplace be secured to the
floor in all cases.
Remove and discard the lifting handles. Bend the tabs
down and secure the fireplace to the floor.
The location of windows, doors and the traffic flow in
the room where the fireplace is to be located should be
considered. If possible, you should choose a location
where the chimney will pass through the house without
cutting a floor or roof joist.
excluding hearth height).
9
FIGURE 3.1
TP - INSTALLATION PLANNING
W415-0711 / 10.03.08