Epson Stylus Pro 7600 Printer Manual page 153

6-4 | Solving Problems
Error messages (continued)
Message Light
SET PAPER Paper Out
LEVER light on
SET INK LEVER —
FRONT COVER Pause light on
OPEN
TURN PRINTER —
PWR OFF AND
ON
UNABLE TO —
PRINT
MAINTENANCE Maintenance
TANK ALMOST Tank light
FULL flashing
CHANGE All lights
MAINTENANCE flashing
TANK
NO Maintenance
MAINTENANCE Tank light is
TANK on
OPTION I/F —
ERROR
SERVICE REQ. All lights
flashing
Explanation
Paper lever was
released during the
printing process or
another operation.
The ink lever was left in
the unlocked position.
Front cover is open.
This message appears
after you clear a paper
jam.
You tried to print while
an error condition was
present or the ink
compartment cover
was open.
The maintenance tank
is almost full.
The maintenance tank
is full.
The maintenance tank
is not installed.
Wrong interface card
installed.
An error has occurred.
6-4
Response
Pull the lever all the way forward, to the
secured position. Start printing again from the
beginning for best results.
Pull the lever down to lock the ink cartridges.
Close the front cover.
Press the Power button to turn the printer off
and back on again.
After 3 seconds the message disappears.
Press the Pause button to exit SelecType
mode. If the message appears again, clear the
error before you print.
Make sure you have a replacement
maintenance tank. See page 5-22.
Replace the maintenance tank. See page 5-22
for instructions.
Make sure the maintenance tank is fully
inserted. See page 5-22 for instructions.
Turn off the printer and remove the card. See
the documentation that came with the card.
Note the error number, then turn the printer off
and back on. If the message remains, contact
EPSON as described on page 3.