I Transmitting A Call; D Using Call Memory; D Calling Back From The Queue Channel - Icom IC-F1721 Instruction Manual

3
BIIS OPERATION

I Transmitting a call

A total of 3 ways for code selection are available—selecting
the call code from memory, entering the call code from the
keypad and calling back from the queue channel record.
D D Using call memory
q While in the standby condition, push [P1] (Digital) to enter
the call code memory channel selection mode.
• " " appears.
C A L L I N G
w Push [Up] or [Down], or rotate [DIAL] to select the desired
call code.
e Push [P0] (Call) or [PTT]* to call.
*PTT call can be made only when PTT call capability is permitted.
NOTE: When no answer back is received, the trans-
ceiver repeats the call 3 times (default) automatically,
and
"WAIT"
error beep sounds and
answer back is received after the calls.
r Push [PTT] to transmit; release to receive.
t Push [P4] (Moni(Audi)) to send the 'Clear down' signal.
16
Appears
0 5 0 0
is displayed during each call. However, an
is displayed when no
"FAILED"
D D Calling back from the queue channel
q While in the standby condition, push [P1] (Digital) for
1 sec. to enter the queue memory channel selection mode.
w Push [Up] or [Down] or rotate [DIAL] to select the desired
record.
< Q U E U E >
- Q U E U E ! -
e Push [P0] (Call) or [PTT]* to call.
*PTT call can be made only when PTT call capability is permitted.
NOTE: When no answer back is received, the trans-
ceiver repeats the call 3 times (default) automatically,
and is displayed during each call. However, an
"WAIT"
error beep sounds and
answer back is received after the calls.
r Push [PTT] to transmit; release to receive.
t Push [P4] (Moni(Audi)) to send the 'Clear down' signal.
"FAILED" is displayed when no