Final Drive Oil - Honda GL1100 interstate Owner's Manual

FINAL DRIVE OIL
Change the oil when specified by the
maintenance schedule.
NOTE:
*
Change the oil with the final drive
warm and the motorcycle on its center
stand to assure complete and rapid
draining.
To drain the oil remove the oil filler
cap (I) and drain plug (2).
2. After the oil is completely drained
check that the sealing washer (3) on
the drain plug is in good condition and
install the drain plug.
Drain Plug Torque:
10-14 N·m (1.0-1.4 kg-m,
7-10 ft-Ib)
3. Fill the final drive with approximately
150 cc (5.1 oz) of the recommended
oil.
Make sure the final drive oil has filled
up to the lower edge of the inspection
hole (4) with the recommended oil.
4. Install the oil filler cap.
(1) Oil fiUer cap
(2) Oil drain plug
(3) Sealing washer
(4) Inspection hole