Stopper Plate Solenoid; Positioning The Paper Retaining Plate Solenoid (Sl2) - Canon FY8-13FW-000DADF-A1 Service Manual

CHAPTER 3 MECHANICAL SYSTEM
I. Stopper Plate Solenoid
1. Removing the Stopper Plate
Solenoid
1) Remove the body cover.
2) Remove the two screws [1], and remove
the original tray mounting plate [2].
[1] [2]
Figure 3-347
3) Remove the two screws, and disconnect
the connector [4]; then, remove the stopper
plate solenoid [5].
Figure 3-348
3-24
COPYRIGHT © 1998 CANON INC.
[1]
[3]
[4]
[5]
CANON DADF-A1 REV.0 DEC. 1998 PRINTED IN JAPAN (IMPRIME AU JAPON)
2. Making Adjustments
1) Secure the solenoid [1] in place where the
stopper [3] (rubber block) butts against the
rear edge of the stopper plate [2] when the
plunger of the solenoid [1] is at the end of
its stroke.
[3] [2]
Figure 3-349
J. Positioning the Paper
Retaining Plate Solenoid
(SL2)
1) Prepare test strips.
Cut a sheet of A4 or LTR paper (64 g/m
into widths of about 70 mm each.
1/3
1/3
1/3
Vertical
Figure 3-350
[1]
2
)
70 mm (approx.)