Washer Care - Whirlpool Duet Sport WFW8300SW Instruction Manual

To reassemble CCU:
1. Align the tab on top of the CCU with the
notch in the cabinet. Also, align the posts
on the back of the CCU with the hole in the
back of the cabinet.
2. Slide the CCU back into place.
3. Reconnect wire harness.
To remove the touchpad/LED assembly:
1. Unplug washer or disconnect power.
2. Disconnect touchpad/LED assembly wire
harness from the CCU.
3. Remove dispenser drawer.
4. Remove left front screw that was covered
by the dispenser drawer.
5. Open door. Under the center of the touch-
pad/LED assembly there is a notch. In-
sert a flat-blade screwdriver in notch to
release the bottom of the touchpad/LED
assembly.
6. On the right hand side behind the touch-
pad/LED assembly, press tab to release
right side of the touchpad/LED assembly.
7. Gently pry up and release the top of the
touchpad/LED assembly. This should
completely release the entire touchpad/
LED assembly.
To remove Motor Control Unit (MCU):
1. Unplug washer or disconnect power.
2. Remove wire harness cover and disconnect
the wire harness from the MCU.
3. With a flat-blade screwdriver, lift the front
tab up and slide the MCU forward.
To remove line/interference filter:
1. Unplug washer or disconnect power.
2. Disconnect the three connectors from the
line filter and power cord.
3. Remove the two screws which secure the
line filter to the top brace.

WASHER CARE

Cleaning the door seal:
1. Open the washer door and remove any
clothing or items from the washer.
2. Inspect the gray colored seal between the
door opening and the basket for stained
areas. Pull back the seal to inspect all
areas under the seal and to check for
foreign objects.
3. If stained areas are found, wipe down these
areas of the seal, using the procedure that
follows:
a) Mix a dilute solution, using 3/4 cup (177 mL)
of liquid chlorine bleach, and 1 gal. (3.8 L)
of warm tap water.
b) Wipe the seal area with the dilute solu-
tion, using a damp cloth.
c) Let stand 5 minutes.
d) Wipe down area thoroughly with a dry
cloth and let the washer interior air dry
with door open.
IMPORTANT:
• Wear rubber gloves when cleaning for
prolonged periods.
• Refer to the bleach manufacturer's instruc-
tions for proper use.
Washer Maintenance Procedure
This washer has a special cycle that uses
higher water volumes in combination with liquid
chlorine bleach to thoroughly clean the inside
of the washer.
NOTES:
• Read these instructions completely before
beginning the cleaning process.
• If necessary, the cleaning cycle may be
interrupted by pressing PAUSE/CANCEL.
This will stop the cycle. A RINSE/SPIN
cycle must then be run to thoroughly rinse
the remaining bleach from the unit. Failure
to do so will cause damage to the unit and
clothing added to the next cycle.
6-9