Line Filter - Whirlpool Duet Sport WFW8300SW Instruction Manual

Disconnect power before accessing.
Replace all parts and panels before operating.
Failure to do so can result in death or electrical shock.

LINE FILTER

Pins A & B
Refer to page 4-8 for the procedure for ac-
cessing the line filter.
To check the line filter at the component ter-
minals, perform the following steps.
1. Unplug washer or disconnect power.
2. Disconnect the wire connectors from the
line filter.
3. Set the ohmmeter to the R X 1 scale.
4. Touch the ohmmeter test leads to the fol-
lowing connector pins (shown above).
The meter should indicate 0 Ω for each
measurement.
Pins A and B
Pins C and D
Electrical Shock Hazard
Pins C & D
To check the line filter at the CCU, perform
the following steps.
1. Unplug washer or disconnect power.
2. Disconnect the line filter connector IF2
(see page 4-5) from the CCU.
3. Set the ohmmeter to the R X 1 scale.
4. Touch the ohmmeter test leads to con-
nector pins 1 and 2. The meter should
indicate 0 Ω.
1
5-3
Connector IF2
At CCU
2