Removing The Door Switch Assembly And The Bellows - Whirlpool Duet Sport WFW8300SW Instruction Manual

REMOVING THE DOOR SWITCH ASSEMBLY
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
1. Unplug washer or disconnect power.
2. Turn off the water supply to the washer.
3. Remove the top cover and the console
(see page 4-2 for the procedures).
4. Remove the lower front access panel
(see step 10 on page 4-11 for the proce-
dure).
5. Open the washer door.
Bellows
Retaining Wire
AND THE BELLOWS
6.
7.
Door Switch
Assembly
4-14
Using a small screwdriver or a pair of
long-nosed pliers, pull the tension spring
on the retaining wire out from around
the front of the bellows, and remove the
wire.
Retaining Wire
Tension Spring
To remove the door switch assembly:
a) Pull the bellows off the lip of the front
panel beside the door switch assem-
bly just enough to access the switch
assembly.
b) Remove the two T-20 Torx screws
from the door switch assembly.
Pull Bellows
Off Lip Of
Panel
Door Switch
Assembly Screws