Supporting The Printhead; Figure 1.2 Printhead Mount - Kodak VERSAMARK DS5110 Operator's Manual

Chapter 1. Getting Started

Supporting the Printhead

Supporting the Printhead
The printhead support must hold the printhead steady to protect it from
vibration. The support must also hold the printhead within 0.0 to 1.00 inch
(2.54 cm) of the substrate, and support the weight of the printhead and
umbilical. Printhead height restrictions vary from model to model.
Maximum printhead height is 1.0 inch (2.54 cm).
Two support options are available: the printhead mount and the printhead
mount stand. Refer to the installation instructions shipped with the
supports for assembly and installation instructions. The supports for the
one-inch and two-inch printheads vary only slightly. The printhead mount
holds the printhead over a label base or document transport (Figure 1.2).
Figure 1.2 Printhead mount
Operator's Guide 1 - 5