MSI MS-6533 User Manual page 58

system from entering power saving modes or awaken it from power sav-
ing modes. Setting options: Disabled, Enabled.
Note: IRQ (Interrupt Request) lines are system resources allocated
to I/O devices. When an I/O device needs to gain attention of the
operating system, it signals this by causing an IRQ to occur. After
receiving the signal, when the operating system is ready, the system
will interrupt itself and perform the service required by the I/O device.
RING Power Up Control, PCI PME Power Up Control, USB Port Wake
Up Control, Hot Key Power Up Control, PS2 Mouse Power Up Control
These fields specify whether the system will be awakened from power
saving modes when activity or input signal of the specified hardware
peripheral or component is detected.
Note: To use the function of "RING Power Up Control", you need to
install a modem supporting power on function.
KB Power On Password
This setting allows you to enter the password to authorize the keyboard
to power on the system.
Power Up by Alarm
This function is for setting date and time for your computer to boot up.
During Disabled, you cannot use this function. During Enabled, choose
the Month, Day, and Time Alarm:
Month Alarm You can choose which month the system will boot up.
Day of Month Alarm You can choose which day of the preset month
Time (hh:mm:ss) Alarm You can choose what hour, minute and
Note: If you have change the setting, you must let the system boot up
until it goes to the operating system, before this function will work.
the system will boot up. Set to 0, to boot every
day.
second the system will boot up.
3-23
BIOS Setup