Clearances And Height Requirements - Vermont Castings DFS3224A Installation And Operating Instructions Manual

When fi nishing a custom cabinet, mantel, or other built-in enclosure,
the opening size to accommodate the fi replace with trim installed
is as follows:
DFS32A/DFS3224A with trim DFS36A with trim DFS42A with trim DFS32A/DFS3224A with trim DFS36A with trim DFS42A with trim DFS32A/DFS3224A with trim DFS36A with trim DFS42A with trim DFS32A/DFS3224A with trim DFS36A with trim DFS42A with trim DFS32A/DFS3224A with trim DFS36A with trim DFS42A with trim DFS32A/DFS3224A with trim DFS36A with trim DFS42A with trim
K 38" 38" 38"
7
J 35 35 / " "
8
1. Bend out the nailing fl anges located on each side of the fi rebox.
2. Slide the fi rebox into prepared framing or position fi rebox in its fi nal position and frame later.
3. Level the fi rebox by checking the top edge of the fi rebox. Shim if necessary.
4. Anchor fi rebox to the side framing members using 8d nails or other suitable fasteners. Refer to Figure 16.
5. The canopy must be installed for safe operation of the heater. Refer to page 12 for canopy installation details.
Nail Sides
Through Nailing
Flanges
26D3310
7
41 41 41 / " " " "
8
7
35 35 / " " " "
8
The fi replace must be installed giving The fi replace must be installed giving
full consideration to the clearance full consideration to the clearance
and height requirements identifi ed in and height requirements identifi ed in
this manual. this manual.
Figure 16 - Location of Nailing Flanges
FIREPLACE FRAMING
7
47 47 47 47 / "
8
7
35 35 35 35 / "
8
Figure 15 - Custom Cabinet
K
J
17