Modes; Print Mode; Operation Modes - Konica Minolta Magicolor 3300 Service Manual

6. MODES

6.1 Print Mode

The printer has four modes, Standard mode, Fine mode, High gross mode, and Super high gross
mode.Modes are switched over under the instruction from the controller.
(1) Standard mode: used for printing with resolution 600dpi
(2) Fine mode: process direction resolution 1200dpi mode
(3) High gloss mode: thick paper, special paper, and high glossed plain paper
(4) Super high gloss mode: thick paper, special paper, and super high glossed plain paper
Relation between the resolution, process speed, print mode and paper mode is shown in the table below.
Paper mode
Plain paper
Thick paper
Special paper
*2
*1: Thick paper-L,Thick paper-H
*2: Label-L , Label-H, OHP, Envelope, Postcard

6.2 Operation Modes

For the operation of the printer, the following five modes are provided.
DIAG TEST mode
The printer is ready for receiving diagnostic commands, or the printer diagnostic function is operating.
WAIT mode
The printer is under the adjustment of print quality.
READY mode
The printer is ready for printing.
PRINTING mode
The printer is under printing.
ERROR mode
Any error was detected in the printer.
Initializing mode
New parts have been just set to the printer (initializing with a new PHD).
Checking Unit mode
Printer is under checking consumable units.
6-450
Print mode
Standard mode
Fine mode
High gloss mode
*1
Super high gloss
mode
Fine mode
High gloss mode
Super high gloss
mode
Resolution/Process speed
600dpi
Simplex Duplex
Full speed Full speed
- -
Half speed Half speed
1/3 speed 1/3 speed
- -
Half speed Half speed
1/3 speed 1/3 speed
1200dpi
Simplex Duplex
- -
Half speed Half speed
- -
- -
Half speed Half speed
- -
- -