Performing Batch Setup Using A Usb Cable - Epson EB-1985WU User Manual

Copy Menu Settings to Another Projector (Batch Setup)
f
Disconnect the power cord from the projector to which you want
to copy settings, and check that all of the projector's lights have
turned off.
g
Connect the USB flash drive containing the saved batch setup file
to the projector's USB-A port.
h
Hold down the [Menu] button on the remote control or the
control panel and connect the power cord to the projector.
i
When all of the projector's lights turn on, release the [Menu]
button. (The lights remain on for approximately 75 seconds.)
When all of the lights start flashing, the settings are being written.
When writing is finished, the projector turns off.
Caution
Do not disconnect the power cord or the USB flash drive from the
projector while the file is being written. If the power cord or drive is
disconnected, the projector may not start correctly.
j
Remove the USB flash drive.
Related Links
• "Copy Menu Settings to Another Projector (Batch Setup)"

Performing Batch Setup Using a USB Cable

You can copy menu settings from one projector to another of the same
model by connecting the computer and projector with a USB cable.
a
You can use this batch setup method with Windows XP and later, or
OS X 10.5.3 and later.
a
Disconnect the power cord from the projector, and check that all
of the projector's lights have turned off.
b
Connect a USB cable to the computer's USB port and to the
projector's USB-B port.
c
Hold down the [Esc] button on the remote control or the control
panel and connect the power cord to the projector.
d
When all of the projector's lights turn on, release the [Esc] button.
The computer recognizes the projector as a removable disk.
e
Open the removable disk icon or folder, and save the batch setup
file to the computer.
a
p.154 f
Eject the USB device (Windows) or drag the removable disk icon to
the Trash (OS X).
g
Disconnect the USB cable.
The projector turns off.
h
Disconnect the power cord from the projector to which you want
to copy settings, and check that all of the projector's lights have
turned off.
The file name for the batch setup file is PJCONFDATA.bin. If
you need to change the file name, add text after PJCONFDATA
using only alphanumeric characters. If you change the
PJCONFDATA section of the file name, the projector may not
be able to recognize the file correctly.
155