Service Code; Care And Maintenance Instructions; Clean The Scanner Glass - Philips PPF 470 User Manual

Service code

! Only use this function when absolutely necessary. If
you are satisfied with your changes to the factory
settings you should not use this function.
Function 45 (Service code) is used to delete some or all of your
changes to the factory settings. This function enables you to
partially or fully reconfigure your device. It is especially helpful if
you have modified settings but find that your fax machine does
not respond as expected.
After deleting some or all of your custom settings please rerun
EASY INSTALL.
The following codes are at your disposal:
Code No. 7117
This code erases all your modifications to the factory settings.
The fax machine will therefore react in exactly the same way as on
first installation.
Code No. 7140
When you enter this code, all your entered settings and data will
be erased, except for:
• your personal outgoing message on your built-in answering
machine
• received messages
• stored short dial numbers
• stored telephone book numbers
• your name
• your telephone number
Example for using a service code:
1 Select MENU 45 and press OK. Enter the service code
(7117 or 7140). Press OK.
2 With </> you can select whether you really want to delete
your settings. Confirm with OK. Your fax machine will be
reset to its original configuration.
Care and maintenance
instructions
The scanner glass and rollers of your fax machine should be cleaned
of paper dust and scuff when necessary.
! Before opening the fax machine, make sure that you
are electrically discharged by e. g. touching the metal
housing of a grounded appliance, a water pipe or
radiator.
! Use a soft, fluff-free cloth lightly moistened with a
little alcohol (96%). You can also use a special cloth
for cleaning fax machines, which is available on the
market. Do not allow any moisture to penetrate inside
the device.

Clean the scanner glass

1 Carefully remove the scanner by pulling it upwards on both
sides.
2 Place the scanner in front of you with the scanning glass
surface face up.
3 Gently wipe the glass surface with a soft cloth (A).
4 Before you re-install the scanner, also wipe the scanner
compartment.
32