Table of Contents
Advertisement
Correction
If you have entered a wrong letter or number in function 13 or 14
you can correct the mistake during the entering as well as later. If
you want to make your corrections later you have to select the
functions for entering numbers or names once again.
1 Position the cursor on the right side of the character you
want to change with </>. Press CLEAR to delete the
character. A long press on CLEAR will delete the whole line.
2 Now enter the correct characters by using the keyboard.
Confirm with OK.
Language of display
1 For selecting the language of the display and the reports,
press MENU and numbers 1 and 1 and press OK.
2 Select the desired language with </> and confirm with
OK.
Type of ring signal
You can choose between ten different ring signals.
1 Enter function 44. Press MENU and numbers 4 and 4
and then OK.
2 Select the desired ring signal with 0 to 9.
3 Confirm your setting with OK.
Volume of the ring signal
You can adjust the volume of the ring signal if the fax machine
is in stand-by mode or if it is just ringing. Please note that
different volumes can be set in S and M mode (see Fax
switch).
1 By pressing </> the display shows the current setting for
about three seconds.
2 Change the volume by pressing </> until the desired
volume is achieved.
Volume of the loudspeaker
1 You can adjust the volume of the loudspeaker at any time
by pressing DIAL (without built-in answering machine)
or l (with built-in answering machine).
2 By pressing </> the display shows the current setting. If
you wish to adjust the displayed value, press </> until the
desired volume is achieved.
3 Finish your entry by pressing STOP.
14
Advertisement
Table of Contents
