BELT DRIVE
EAS00321
CHECKING THE PRIMARY SHEAVE WEIGHTS
The following procedure applies to all of the pri-
mary sheave weights.
1. Check:
•
primary sheave weight
Cracks/damage/wear
2. Measure:
•
primary sheave weight outside diameter
a
Out of specification
Primary sheave weight outside di-
ameter
15 mm (0.591 in)
<Limit>: 14.5 mm (0.571 in)
CHECKING THE SLIDER
1. Check:
• slider©
Damage/wear^ Replace
EAS00322
CHECKING THE SECONDARY SHEAVE
1. Check:
•secondary fixed sheave
•secondary sliding sheave
Cracks/damage/wear
ondary fixed and sliding sheaves as a
set.
2. Check:
•torque cam groove
Damage/wear
fixed and sliding sheaves as a set.
3. Check:
•guide pin
(2)
Damage/wear
fixed and sliding sheaves as a set.
5-47
ENG
-*
Replace.
-*
Replace.
-*
Replace the sec-
©
-*
Replace the secondary
-*
Replace the secondary