Set Remote Access Code; Set Message Alert Tone - VTech DS4122-X Instructions Manual

Answering system operation

Set remote access code

A two-digit security code is required to access the answering system remotely from any touch tone
telephone. The code preset at the factory is 19. You can set the code from 10 to 99.
To set the remote access code:
Press SET UP when in idle mode until the system announces the remote access code setting.
1.
2. Press /SKIP or /REPEAT to change the remote access code by one, or press and hold /SKIP
or /REPEAT to change it by increments of ten.
next setting, or press

Set message alert tone

This feature programs the system to beep every 10 seconds to alert you of new messages. The
beeping will stop when all new messages have been reviewed.
To set the message alert tone:
1. Press SET UP when in idle mode until the system announces the message alert tone setting.
2. Press /SKIP or /REPEAT to alternate between on or off, then press SET UP to save the setting,
and go to the next setting or press
DS4122-X CIB 0110 08.indd 29
Press SET UP to save the setting and go to the
Press
/PLAY/STOP to save and exit set up mode.
/PLAY/STOP to save and exit set up mode.
www.vtechphones.com
• The answering
system must be
turned on for the
message alert tone
to function.
29
01/11/2008 11:55:28