Set Number Of Rings; Set Telephone Base Ringer - VTech DS4122-X Instructions Manual

• Setting the number
of rings to toll saver
can save on long
distance charges
if you call to check
your messages
from a remote
location because
the answering
system will answer
the incoming call
after two rings only
when there are new
messages.
28
DS4122-X CIB 0110 08.indd 28
Answering system operation
Answering system setup
The answering system uses voice prompts to guide you through the steps
to setup the answering system. Press
exit the SET UP menu.

Set number of rings

This feature allows you to select the number of rings before the answering
system answers. You can choose from two, four or six rings or toll saver. With
toll saver selected, the answering system answers after two rings when there
is a new message and after four rings when there are no new messages.
To set the number of rings:
1. Press SET UP when the telephone is not in use and the system announces
the current number of rings setting.
/SKIP or /REPEAT until the system announces the desired
2. Press
setting, then press SET UP to save the setting and go to the next setting,
or press /PLAY/STOP to save and exit set up mode.

Set telephone base ringer

This feature allows you to select the telephone base ringer volume levels.
You can choose from HI (high), OF (off) or LO (low).
To change the setting:
1. Press SET UP in idle mode until the system announces the telephone
base ringer setting.
/SKIP or
2. Press /REPEAT until the system announces the desired
telephone base ringer volume level, then press SET UP to save the
setting and go to the next setting or press
exit set up mode.
www.vtechphones.com
/PLAY/STOP anytime to save and
/PLAY/STOP to save and
01/11/2008 11:55:28