Wallplate Installation - Trane TAYSTAT 575 Installation Instructions Manual

ELECTRONIC HEAT PUMP THERMOSTAT
NO

Wallplate Installation

Mount tthermostat horizontally on the wall or on a 2 in. x 4
in. wiring box.
1. Position and level the wallplate (for appearance
only). The thermostat functions properly even when
not level.
2. Use a pencil to mark the mounting holes. See
Fig. 2.
3. Remove the wallplate from the wall and drill two
3/16 inch holes in the wall (if drywall) as marked. For
firmer material such as plaster or wood, drill two
7/32 inch holes. Gently tap anchors (provided) into
the drilled holes until flush with the wall.
4. Position the wallplate over the holes, pulling wires
through the wiring opening.
5. Loosely insert the mounting screws into the holes.
6. Tighten mounting screws.
Pub. No. 11-HD28D2-1
69-1591–1
NO
[1.5 METERS]
Fig. 1. Typical location of thermostat.
2
YES
NO
5 FEET
WIRES
THROUGH WALL
WALL
ANCHORS
(2)
Fig. 2. Mounting the wallplate.
M10106
WALL
MOUNTING
HOLES
MOUNTING
SCREWS
M6530