Table of Contents
Advertisement
PRECAUTIONS
1. INSTALLATION
1
The FC15/22 should be installed by a qualified service technician.
Note: The packing material should be disposed of properly.
2
To obtain the best possible results, this copier should be used in conjunction with a
dedicated AC power line at the following ratings:
220-240 V, 50/60 Hz, 9 A
Notes:
1. The use of other appliances or other equipment on the same line as this copier may adversely
affect performance and copy quality.
2. Be sure to use a 3-conductor, grounded wall outlet.
3. In areas where a 2-pin plug is used, the copier must be grounded for safety.
Never ground it to a gas pipe, a water pipe, or any other object not suitable for grounding.
3
After a suitable place has been selected for the installation for the FC15/22, please do
not change it. Avoid excessive heat, dust, vibration and direct sunlight. Also, provide
proper ventilation as the copier emits a slight amount of ozone.
Notes:
1. Recommended environmental range for use is as follows:
• Temperature: 10~30 C/50~86 F
• Humidity: 20~80%RH
2. To insure optimal operation, allow clearances of at least 80cm on the left, 80cm on the right
and 10cm in the rear.
The copier should be located near a wall outlet which should be easily accessible.
5
Advertisement
Table of Contents
