Crankcase, Crankshaft; Removal Of Crankcase - Husqvarna 181 Workshop Manual

8
Crankcase,Crankshaft
Removalof crankcase
The following components have already been removed: chain and bar,
centrifugal clutch, flywheel, carburetor, cylinder and piston.
Drain the oil tank and fix the chain saw in the clamping device No.
5025102-01.
Remove the oil pump from the crankcase. Note the thrust!
Lift the oil hose and filter out of the oil tank.
Remove the cylinder base gasket.
Remove the six screws (three on each side) that connect the crankcase to the
tank unit.
Separate the crankcase from the tank unit.
27