5 H
Electric system
Fit holding bar No. 5025149-01
on the flywheel and loosen the nut with a
box spanner (14 mm). Fit puller No. 5025026-01
on the holding bar and re-
move the flywheel.
Assembly is made in reverse order. The flywheel nut should be tightened by
torque 30–35
Nm. Do not forget the washer under the flywheel nut! Check
the gap between flywheel and electronic unit. Use air gap tool No.
5025134-02.
F
s
p
To ensure proper connection between switch spring and ignition cable, use
assembling pliers No. 5025006-01
for fitting the switch spring on the
ignition cable.
18