Swann DVR16-1500 Instruction Manual page 13

The Setup Wizard
Wizard: Network Settings
NIC Type: What sort of network you're using. There are a few to
choose from. The vast majority of users will use the default option
of 10M/100M/1000M Self-adaptive. If you're using a network
other than this type, chances are you know about that.
Enable DHCP (check-box):
you're specifically running a manually addressed network
(sometimes called static IP addressing) or your router doesn't
support DHCP.
IPv4 Address, Subnet Mask, Default Gateway:
DHCP, these values will self-populate. If you're using a manually
addressed network, you'll need to set these to match the other
devices on your network.
To learn more about the Network settings of the DVR - see page
18.
When you have completed the setup wizard, it is very important
to check the settings for UPnP on page 14 and More Settings
on page 15. The Server Port (8000) is used to access the DVR
remotely using the SwannView Plus client software on your
computer and the SwannView Plus app on your Smartphone or
Wizard: HDD Management
Here, you can view and initialize the hard drive(s) in the DVR.
Typically, there will be only one entry here, the HDD which came
with the DVR (if one was included). Each drive will be identified
and be listed along with statistics such as Capacity, Status and
Free Space.
If you're booting the DVR for the first time, the HDD should already
be initialized or if you've just installed a new HDD, then you'll need
to initialize the drive.
Init: Initializes the HDD so that it's ready to accept data.
Warning: Don't initialize a drive that already has data on it, as the
initialization process will erase any information on the drive.
Ensure that this is checked unless
When you're using
Tablet.
13