Hazard Switch - Honda CB1000R Owner's Manual

Hazard switch (5)

This system should be used only when your
motorcycle is stopped under emergency or
hazardous conditions. To turn it on, turn the
ignition key to the ON position, and then press
the switch marked
signals will blink simultaneously.
All of the turn signals can blink without the
ignition key.
To operate this function, proceed as follows:
1. Turn the ignition key to ON position and then
press the hazard switch (5)
2. All of the turn signals will keep blinking even
after you turn the ignition key to OFF position.
3. You can turn off the turn blinking signals by
pressing the hazard switch back to the off
position.
If the switch is left in the off position for
more than two seconds and then moved
back to the position again, the turn
signals will not be on.
.The front and rear turn
marked.
Be sure to turn the switch off when the hazard
warning is no longer required, or the turn
signals will not work properly, and may
confuse other drivers.
If all the turn signals are left blinking with the
engine stopped, the
discharged.
(5) Hazard switch
battery will be
(5)
65
4