Panasonic WV-NW484S Setup Manual page 18

No. Item
(4) [Image quality]
Default: Normal
Low
Normal
Fine
(5) [Refresh interval (MPEG-
4)]
Default: 3 sec
(6) [Transmission type]
Default: Unicast port
(AUTO)
Unicast port
(AUTO)
Unicast port
(MANUAL)
Multicast
*1
(7) [Unicast port]
Default: 32004
*2
(8) [Multicast address]
Default: 239.192.0.20
Select the image quality of MPEG-4 images.
Movement is given priority. (Images become grainy.)
This is the normal setting.
Image quality is given priority. (Operation becomes slower.)
Select an interval (i-frame interval) to refresh the displayed MPEG-4
images from the following:
1 sec/2 sec/3 sec/4 sec/5 sec
If errors occur frequently on the network environment in use, shorten the
refresh interval for MPEG-4 to reduce image distortion. Note, however,
that the refresh interval may be longer than the set value.
Select the transmission type of MPEG-4 images.
When "Unicast" is selected, up to eight users can access a single camera
simultaneously.
When "Multicast" is selected, any number of users can access a single
camera simultaneously.
When MPEG-4 images are transmitted by Unicast transmission, the port
number to be used is automatically assigned.
................................................................................................................
Note
• When it is unnecessary to fix the port number from which to transmit
MPEG-4 images, for example, when using the camera on a network,
we recommend selecting "Unicast port (AUTO)".
.....................................................................................................................
Select this item when MPEG-4 images are transmitted by Unicast
transmission manually.
Select the port number to be used.
................................................................................................................
Note
• When transmitting MPEG-4 images via Internet, it is necessary to set
the verified port number on a broadband router. For further
information, refer to the Operating Instructions for the broadband
router in use.
.....................................................................................................................
When transmitting MPEG-4 images by multicast transmission, enter
[Multicast address], [Multicast port] and [Multicast TTL].
Enter the unicast port number (used to transmit images from the camera).
Available port numbers: 1024 to 50000 (even numbers only)
Enter the multicast address.
Images will be transmitted to the designated multicast address.
Available addresses: 224.0.0.0 to 239.255.255.255
18
Description
(2/3)